Features
-
Draws power from the PC through 'Y' connector.
-
Clean installation appearance
-
Transmit data at distances up to 4,000 feet (1,219 m).
-
4-wire full duplex or 2-wire half duplex operation.
-
Pin connections on RS485/422 side mate directly
to many multimedia units (Sony, BTS, Grass Valley, etc.)
-
Baud rates to 1 MBaud
-
Choice of a Single (ANC-6090S) or Dual (ANC-6090D)
channel version.
-
ANC-6090 same adapter for external applications
- laptops and portables
Overview
Hardware Flexibility
RS-422/485 - signal levels meet or exceed the Recommended Standards
(RS). The RS-232C side mates directly with a PC's DB-9 serial port
connector accessible through a motherboard or addon card 10-pin IDC.
This makes the adapter an ideal solution for connecting external RS-485/422
equipment up to your PC compatible computer where powering and internal
mounting of the adapter is desired. Check the connector type and
location on your motherboard and/or internal addon card to verify installation.
Adapter uses 1 unused card slot, or the adapters can be remounted onto
the chassis DB-9 punchouts where the RS232C interface connectors are usually
mounted.
Software Compatibility
Because the adapter just converts RS-232C to and from RS-485/422
level signals, no specific software modifications are required to operate
the adapter with off-the-shelf applications that use the serial communications
port. The data direction can be changed on the adapter by using the
RTS line.
Easy to Use
Shipped ready for installation. Jumpers are pre installed for
the most commonly applied configuration and a comprehensive
user's manual is included.
Warranty
Every Antona product is built and tested to meet high standards
of quality and reliability. Our products are covered with a one year
warranty.
Specifications
Product |
ANC-6090S |
ANC-6090D |
Number of Interfaces |
1
|
2
|
Interface Converts to/from |
RS-232 to
RS-485 or RS-422 |
RS-232 to
RS-485 or RS-422 |
RS-485/422 Connector |
Female DB-9 SMPTE |
Female DB-9 SMPTE |
Control Signals |
RS232: option for RTS transmit/receive
enable |
Baud Rate |
to 1M baud |
Impedance |
120 ohms |
voltage |
3V @6ma minimum |
External Power |
+5v from internal PC power supply |
Note: RTS connected to DCD, DTR connected to DSR
ANC-6090S
replaces ANC-6091, ANC-6090D replaces ANC-6092 |